Electronics Forum | Tue Mar 14 12:16:10 EDT 2023 | proceng1
Are these molten solder bubbles, or another substance "foaming" up on the surface?
Electronics Forum | Tue Mar 14 14:34:02 EDT 2023 | joeljacobo
Hi, I think they are a bit of both. When they pop the bubbles something like a foam is generated.
Electronics Forum | Tue Mar 14 20:42:24 EDT 2023 | stephendo
In a previous lifetime, we had a selective solder machine where I would see solder splashes in the roof of it. I thought someone might have been putting the solder extremely high. But when it was melting there would be bubbles that burst. The manufac
Electronics Forum | Tue Mar 14 21:30:45 EDT 2023 | joeljacobo
Thank you very much for your contribution Stephen
Electronics Forum | Wed Mar 15 15:24:52 EDT 2023 | joeljacobo
In this case nitrogen is not used but thanks for your contribution!
Electronics Forum | Wed Mar 15 11:34:28 EDT 2023 | proceng1
I'm sure this isn't the same situation, but we did have a selective solder machine with crazy dross and solder ball build up. Turns out the operator switched the low pressure nitrogen line used for solder level and the high pressure nitrogen line fo
Electronics Forum | Mon Mar 13 21:21:40 EDT 2023 | joeljacobo
Hello colleagues, I appeal to your expertise in this matter that has taken me by surprise. A week ago it was decided to change the solder brand for the wave machine, (only the brand, the alloy is the same). The pot was emptied and filled with the
Electronics Forum | Wed Oct 30 16:05:08 EST 2002 | msimkin
Hi, I have received a report form a board supplier, analysing the reuslts form non wetting problems we have been expereincing with their boards. I assumed it was due to the gold layer being too thin, thus allowing the nicklel layer to be exposed and
Electronics Forum | Thu Oct 31 11:08:12 EST 2002 | soupatech
Being very new to SMT I won't assume I know what the problem is but.... I had lots of air pockets in solder joints, 95% of the boards. Everyone I spoke to thought it was a problem with my process but when one board was sent to our supplier they admi
Electronics Forum | Thu Aug 27 08:34:50 EDT 2009 | floydf
I am having trouble with little air bubbles in my conformal coat. It ranges from a few pin sized bubble to looking like spit. We are using Dow 2620 silicone conformal coat applied with a PVA sprayer machine. The conformal coat comes in bladder bags t
.gif)
